Launch the Maglev Configuration wizard from CIMC and configure the primary node in the cluster: Configure the Primary Node In this table successfully, continue by completing first-time setup, as explained in First-Time Setup Workflow.Įnable browser access to the appliance's Cisco Integrated Management Controller (CIMC) graphic user interface: Enable Browser Access to CIMC.Įnsure trouble-free configuration by checking and adjusting hardware and switch settings: Execute Pre-Flight Checks. The following table details the configuration tasks and the order in which to perform them. If you choose cluster mode for your initial deployment, be sure to finish configuring the primary node before going on to Be sure whenĬonfiguring the standalone host to set it up as the first, or primary, node in the cluster. If you choose standalone mode for your initial deployment, you can add more appliances later to form a cluster. The preferred option for large deployments. In this mode, all services and data are shared among the hosts.
This option is usually preferred for initial or test deployments andĬluster: As one of a cluster of up to three nodes. Standalone: As a single node offering all functions. You can deploy the appliance in your network in one of two modes:
